Ring terminals on wire are required. Use these breakers for DC protection in OutBack FLEXware enclosures, and MidNite E-panels when equipped for the Apollo T-80 controller. Stud size is 1/4" on 80A and smaller, 5/16" on 100A and 125A and 3/8" on 175A and 250A.
MidNite's breakers are rated to break the full rated load at the rated voltage repeatedly, with NO DAMAGE. Always use a properly sized breaker for disconnecting...
OutBack Power PNL-80-DC Panel Mount Circuit Breaker 80 Amp Single Pole with stud terminals on the back. Ring terminals required.
OutBack offers a full line of integration hardware designed to...
The Xantrex 100A, panel mount breaker is designed for use in the XW Power Distribution Panel. This breaker is typically used as the charge controller input breaker for the Xantrex 160A MPPT...
MidNite's breakers are rated to break the full rated load at the rated voltage repeatedly, with NO DAMAGE. Always use a properly sized breaker for disconnecting.
Environmental Rating - Type 1...
MidNite's breakers are rated to break the full rated load at the rated voltage repeatedly, with NO DAMAGE. Always use a properly sized breaker for disconnecting.
Environmental Rating - Type 1...
